Transmission Warehouse in Waldorf, MD’s Car Care Tips

Transmission Warehouse in Waldorf, MD, wants to make sure you have the best experience possible. That is why we have added some great features.

Very Important Installation Guide Information

Man Hand On Car Gear To Drive The Car - Waldorf, MD - Transmission Warehouse
Hand On Gear Stick - Waldorf, MD - Transmission Warehouse

Transmission Checklist 

  • Scan original vehicle codes and keep them before removing transmission.
  • Compare replacement transmission and torque converter to original before installation.
  • Transmission cooler and lines must be flushed or replaced.
  • Inspect flex plate closely and check for cracks or any damage.
  • Inspect all engine and transmission mounts for wear and damage.
  • Be sure both dowel pins are clean, installed properly, and are in good condition.
  • Do not remove the converter to add trans fluid two the converter.
  • Do not remove the converter bracket into you are ready two boating the trans to the engine
  • After installing the transmission, and five quarts of trans fluid, then start the engine up.
  • Then add five more quarts and then put the vehicle in reverse and drive and then back into park.
  • The transmission and the trans cooler take from 12 to 15 quarts of fluid.
  • Let the vehicle run for about 10 minutes, so you can check for the correct fluid level.
  • The type of fluid 4L60E Chevy/GMC trans calls for is dexron 3 and the late model take dexron VI
  • The type of fluid 4R75W Ford trans calls for is Mercon LV
  • Road test the vehicle for 5 miles to make sure the vehicle is working correctly.
  • Check the fluid level one final time.
  • If you feel the vehicle is not working correctly stop driving the vehicle immediately.
  • Contact the warranty department. (833)-BUY-TRAN. 
  • Scan original vehicle codes and keep them before removing transmission.
  • Compare replacement transmission and torque converter to original before installation.
  • Transmission cooler and lines must be flushed or replaced.
  • Inspect flex plate closely and check for cracks or any damage.
  • Inspect all engine and transmission mounts for wear and damage.
  • Be sure both dowel pins are clean, installed properly, and are in good condition.
  • Do not remove the converter to add trans fluid two the converter.
  • Do not remove the converter bracket into you are ready two boating the trans to the engine
  • After installing the transmission, and five quarts of trans fluid, then start the engine up.
  • Then add five more quarts and then put the vehicle in reverse and drive and then back into park.
  • The transmission and the trans cooler take from 12 to 15 quarts of fluid.
  • Let the vehicle run for about 10 minutes, so you can check for the correct fluid level.
  • The type of fluid 4L60E Chevy/GMC trans calls for is dexron 3 and the late model take dexron VI
  • The type of fluid 4R75W Ford trans calls for is Mercon LV
  • Road test the vehicle for 5 miles to make sure the vehicle is working correctly.
  • Check the fluid level one final time.
  • If you feel the vehicle is not working correctly stop driving the vehicle immediately.
  • Contact the warranty department. (833)-BUY-TRAN. 

If you have further questions, contact us today.